We leave everything alone for the time specified in the instructions

[shapanwwuopi]

We form the end of the plate blank with a disk rotated by a grinder.We put the blank in its place and, using the adjacent whole plate as a guide, mark the length with a pencil.

We cut along the mark and break off the blank plate with pliers. We clamp it in a vice and make a shallow cut in the center at the top with a knife and a hammer.
We put the blank on a wooden block and make a hole at the base of the cut with a punch and a hammer, which we grind with a sewing needle.

We clean the processing area with sandpaper. We put the homemade plates in their places and solder the ends of the corresponding windings to them.

We mix two-component epoxy glue according to the instructions and apply it to the plates with the tip of a flat screwdriver so that it gets into the gaps between the plates.


We wrap the collector with glued plates several times with aluminum wire, creating tension and twisting the ends together.


After that, we untwist the wire and remove it. But a more hong kong telegram data reliable fastening of the lamellas would be to install two fiberglass bandages soaked in hot glue.
We remove the epoxy resin from the surface of the lamellas with a knife, since it is a dielectric. Then we process the lamellas with a metal file until they shine like copper.


Since there is no lathe to turn the collector with new lamellas, we return the anchor to its place and unscrew the brushes.

We measure the diameter of the hole for the brushes with a caliper and plane a suitable rod from wood with a knife and bring it to the desired size with sandpaper.


By rotating the tool by the spindle, you can see the rotation of the collector through the hole for the brushes. We use this effect to grind the contact plates.